Sample Code Revit Batch Processor 1.1.16 documentation
Panel: Families | Menu: SwapFamilies
Tools to replace instances of one family type with another in the current project.
All three report, as tables in the output window, the instances they could not swap:
Table |
Meaning |
|---|---|
Host Families containing instances not swapped |
Instances nested inside another family |
Host Groups containing instances not swapped |
Instances inside a group |
Those need resolving by hand — swapping nested and grouped instances is not automated.
Swaps instances according to CSV instruction files.
You select a folder, not a file. The tool searches it for files whose names begin with
SwapDirective and end in .csv, and reads every directive it finds across all of them.
Directive file columns:
Source Family Name, Source Family Category Name, Source Family Type Name,
Target Family Name, Target Family Type Name
Use when: You have a predefined substitution list to apply across a project — for example moving from concept families to construction-issue families.
Swaps instances through two selection dialogs:
Select the source family type to replace, from the types loaded in the project.
Select the target type to use instead. The list is filtered to the source type’s category.
All eligible instances of the source type are swapped.
The same as Swap By Selection, except the source is identified by picking an instance in the model rather than choosing from a list. You then select the target type as before.
Afterwards it offers to save the swap you just performed as a SwapDirective CSV through
a save dialog. That file can be fed straight back into Swap By Directives, so a one-off
pick can be recorded and replayed on other models.
Instances nested in families or inside groups cannot be swapped automatically; they are reported for manual attention.
Instance parameter values are preserved where the target type carries a parameter of the same name. Type parameters come from the target type.
Progress is shown in a cancellable progress bar.